FP52

■ Contrôle des ventilateurs intelligent et sophistiqué

■ Large gamme de température

■ Bel affichage à cristaux liquides avec un néon de couleur saphir

■ Boutons en aluminium poli et biseautés

 

Spécifications

Couleur Noir , Argent
Matériau utilisé Panneau frontal en aluminium, châssis en acier
Longueur des Câbles Dual air intake mesh
Application Baies de 5.25"
Sortie du ventilateur 0V, 6 ~ 12V
Ecran LCD Temperature, fan speed, alarm clock, time, system status
Temp. Range 0 ~100°C
Longueur du câble 800 mm
Poids net 220g
Dimensions 158 mm (L) x 42 mm (H) x 85 mm (P)
Remarque :
Maximum output for one channel – 0.8amp (9.6W)
Maximum combined output for all three channels – 1.5amp (18W)

 




  • Téléchargements
  • Recommandations
  • Tests de products
  • Q&R


Describe Ver Taille Téléchargement
FP52 Manual v1.0 1,298 KB

FT01 Performance Standard ATX tower chassis with aluminum unibody plus...
RV01 Extreme enthusiast extended ATX tower chassis plus...
SG12 Refinement of classic small form factor case plus...
Maximum output for one channel ¡V0.8amp
Maximum output for all three channels ¡V1.5amp
So you can have for example, 0.8amp on first, 0.3amp on second, and 0.4amp on third channel. But you can't have 0.8amp on all three channels at the same time.
The FP52 accepts only fans powered by 3pin connectors so you will need to use a 4pin to 3pin adapter for your 4pin fans.
Please make sure all the connections to FP52 are correct and double check your temperature settings again. There are three temperature values (CPU, SYS, HDD), if any of them are exceeded, the alarm will sound.
Your FP52 maybe defective. Please contact the SilverStone office closest to you for information on how you can obtain a replacement unit:
http://www.silverstonetek.com/contactus.php
Please check to see if the battery for the FP52 is properly seated in its slot. If it is, then the battery may need to be replaced. The FP52 uses "CR2032" sized lithium battery that is readily available in most electronics store.