DIY Parts     ES02-USB

■ Control your computer from anywhere in the room using 2.4GHz RF remote

■ 2.4GHz receiver utilizing universal USB 9 pin male connector

■ Works as far away as twenty meter

■ Includes power / reset switch Y cable

■ Includes left and right angled USB adapters

         ES02 is a convenient remote switch kit designed by SilverStone to wirelessly turn on / off and reset a computer. By utilizing existing standard 2.4GHz RF wireless technology, USB 2.0 internal 9 pin connector, and power / reset pin headers on a motherboard, the ES02 kit is easy to install and use within 20 meters of a connected computer. An included Y cable ensures your computer case’s own power and reset buttons can be used concurrently with the ES02 if needed. Users looking for a simpler security solution than software access control will find ES02 to be a good alternative. Those with computers located in hard to reach area or has special usage scenarios will also find the ES02 to be very handy.


Model No. SST-ES02-USB
Adapter card
Adapter form factor USB 2.0 9 pin male connector x 1
Operation frequency 2.4GHz
EIRP 3.76dBm (Measured max.)
Operating range 20 meter (Free space)
Environment Operating temperature : 0℃~40℃ (32℉~104℉)
Storage temperature : -40℃~70℃ (-40℉~158℉)
Operating humidity : 10%~90% non-condensing
Storage humidity : 5%~90% non-condensing
Net Weight 30g
Dimension 30mm (W) x 10mm (H) x 60mm (D)
Remote control
Operation frequency 2.4GHz
EIRP 3.76dBm (Measured max)
Operating range 20 meter (Free space)
Battery type CR2032 (Lithium manganese button battery)
Nominal voltage DC 3.0V
Battery environment Operating temperature : -20℃~70℃ (-4℉~158℉)
Storage temperature : 10℃~40℃(50℉~104℉)

2.4GHz wireless computer power and reset remote switch more...
2.4GHz wireless computer power and reset remote switch more...
ES02-USB manual
417 KB
ES02-USB High resolution photos
1,605 KB

ES02-USB eDM (es02-usb-edm-en.pdf)
150 KB

A:Every motherboard has different setup and placement for its USB 2.0 9pin pin headers, so please refer to your motherboard's manual to confirm which one supports USB standby power function and connect ES02-USB to it accordingly.

A: Please make sure USB standby function is turned on for the pin header the ES02-USB is connected to in the motherboard’s BIOS / UEFI setting. If your case is made of metal, the remote control distance will be affected. The affected distance will vary depending on material composition, thickness, and ES02-USB’s relative location inside the case.

A:When pressing the remote control button, please make sure LED on the remote control is responding as well as it indicates if the remote control is sending signal.

A:ES02-USB is designed to fit different sizes and different brands of motherboard. However, we’ve found MSI branded motherboards to have slightly smaller plastic frame around their USB pin headers, making for unusually tight fit with ES02-USB. So please take extra care and remove ES02-USB slowly while holding down the plastic frame to avoid pulling it off while removing the ES02-USB.